Storage

Short-Term Storage

1. Allow the unit to cool and clean with mild soap and water.
2. Tighten all hardware to correct specifications.
3. Inspect unit for visible signs of wear or damage. Repair as needed.
4. Prepare fuel system for storage.
   📋 NOTE

   Gasoline left in the fuel system without a stabilizer, even for short periods of time, deteriorates and leaves gummy deposits in the system that may cause damage. For the best results, add stabilizer to all fuel containers whenever purchasing fuel. Add the stabilizer to the container before adding fuel.

   1. Add fuel stabilizer according to manufacturer's instructions to the fuel tank and any fuel containers with remaining fuel.
   2. Operate engine outdoors for at least 5 minutes to allow stabilizer to reach the carburetor.
   3. Close fuel valve and allow engine to stop on its own from lack of fuel.
   4. Turn key OFF and remove it from the ignition. Cover key slot with rubber boot to prevent water intrusion into ignition.
   5. Store unit in a cool, dry, protected area. Do not store unit outdoors.

Long-Term Storage

1. Perform short-term storage procedures.
2. Lubricate as directed in Maintenance Schedule.
3. Apply oil to all pivot points and pin connections.
4. The pillow block bearings require approximately 2 grams of grease at each interval.
5. Touch-up all scratched painted surfaces.
6. Store battery in a cool, dry, protected area.
7. Store unit in a cool, dry, protected area. Do not store unit outdoors.

Start-Of-Season Preparation

Before adding fuel for the first time after long-term storage, add fresh, stabilizer-treated fuel to fuel tank and any fuel containers with remaining fuel. Charge and install the battery.